fishing rod holder for pelican kayak pelican-swivel-fishing-rod-holder-ps1262 – Confluence Outdoor ensuring it not only serves its purpose but also enhances the overall look of your watercraft Kayak Crate and PVC Rod

Once a big Peacock Bass is hooked, he will head straight for the cover he feels safe in, and will give you more fight per pound than any fresh water fish you have ever hooked before

The right choice of bait depends entirely on the time of year, water clarity, tidal conditions, and the specific baitfish the bass are huntingwhether thats sandeels, sprats, or crabs

While you may be able to catch the fish in these areas on more aggressive topwaters and crankbaits, you can almost always pick off a few more by working the area slowly with a Texas rig

The minnow is internally weighted, featuring a dorsal fin that doubles as a weed guard, for fishing through light cover

Drift the shaft sleeve retaining pin out to the right, push it to the right only, the pin it spined on one side and will not go the other way The bearing retaining plate comes off next, these screws were a little soft be careful With the retaining plate off out comes the bearing, the brass shaft centering bushing, the brass spacer, and then the aluminum spacer Next remove the three screws holding the side plate noting the bottom screw is longer than the other two, at least there was grease inside the gear housing, remove the last screw and remove the shaft retaining plate The handle shaft pulls out, and remove the brass shaft bushing, the anti-reverse dog and anti-reverse selector come out, make not of the direction of the anti-reverse dog and the selector switch spring is tight in the hole, be carful you don't bend it Here we are all torn down, except the bail mechanism Everything goes back together in the reverse order with no surprises, but lots of grease The shaft bearing was unsealed from the factory so it cleaned up real easy and was hand packed with grease, I'm more worried about corrosion than feather light spinning All done and back together, no real surprises except the sleeve pin, which drives only one way, was kinda hard to hold the reel, drift and hammer...