eyelets fishing pole Rod Eyelet Repair Kit Spinning Rod Guides Stainless Steel Cera Top Eye Replacing Eyelet On

Materials: -PVC Pipe: 1 1/4" (or bigger) schedule 40 pvc pipe (cut to roughly 31" section, or longer depending on what rods you plan on using with it) -Fiberglass surveying stake (or any other sturdy material that could be used as supports, such as wooden dowels) -Wire Hanger -Empty Deodorant Container -Thick Rubber Band -Spiral Rod Holder -Clip -Duct Tape -20lb+ mono -Plastic Beads for spacers (optional) Tools: -Dremel, with cutting bit (to cut PVC and Deodorant Container) -Wire Cutter, or pliers with wire cutter -Needle-nose Pliers -Drill -Chop Saw (or some other saw to cut the Survey Stake) -7/16 or 1/2" drill bit -Drill bit to match Survey Stake size -Drill bit to match Wire Hanger size -Super glue -Sharpie (Permanent Marker) -Safety Glasses -Straight Edge These materials and tools are not a set-in-stone list

The cast is performed by snapping the rod backward to the 2 o'clock position, then casting it forward in a smooth motion, allowing the lure to pull the line from the reel

Next is one of the carbon fibre brake discs, soaked in the ATD grease and the excellent condition of its directionally uniform tightly woven surface signals that it still retains substantial service life

These are very small but pack a punch in terms of quality and performance

I knew from a previous capture that it had been caught on a big bait too, which made me confident that these bad boys were going to be the edge